Control Arms
3 products
RS-RRS-R 13+ Scion FR-S / Subaru BRZ Rear Lower Control Arms RLAT065$609.001 availableShips in 2 to 7 Days
RS-RRS-R 2012+ Scion FR-S / Subaru BRZ Rear Toe Control Arms XTCRT065$289.00Call for availabilityShips in 2 to 7 Days
RS-RRS-R 2012+ Scion FR-S / Subaru BRZ Trailing Rod TLRT065$429.00Call for availabilityShips in 2 to 7 Days
About Control Arms
Adjustable arms are how a lowered car gets its alignment back once the factory adjustment gives up. Drop a multilink rear like a Civic, a WRX or a 3 Series and camber goes negative past anything the stock eccentric bolt can reach. An adjustable arm replaces the fixed one and hands the shop the range it's missing. Toe arms do the same job for rear toe, and toe is what actually shreds the tire.
Front arms are less about camber and more about geometry and bushings. Swapping a front lower on a strut car trades soft rubber for urethane or a spherical bearing, which sharpens turn in and adds road noise, and you don't get one without the other. Some front arms add caster, which steadies the car in a straight line and gives more camber in a turn without any at rest.
Three things to look at on any arm listing. The end type, since a rod end without a boot fills with grit. The adjustment method, because a turnbuckle you can set on the car beats an arm you have to unbolt twice. And whether it'll clear the wheel you picked, since a thick arm and a wide low offset wheel can meet at full lock.
- By brand
- RS-R3
- By make
- Honda control armsSubaru control armsFord control armsTesla control armsToyota control armsBMW control armsDodge control armsChevrolet control armsNissan control armsInfiniti control armsMazda control armsVolkswagen control arms
- More
- All Suspension
Common questions
- Do I need camber arms after lowering
- On a mild drop, usually not. On a deeper one, yes at the rear of most multilink cars. The factory rear adjustment is a small eccentric bolt with limited range, and past it the tire starts wearing on the inside edge. Get the alignment first. If the printout shows rear camber stuck at the end of adjustment, that's when you buy the arms.
- Spherical or urethane bushings
- Urethane for a daily, spherical for a track car. Urethane takes most of the slop out of factory rubber and stays quiet if you grease it going in. A spherical bearing removes every bit of it, passes each bump straight through, and wears faster in rain and grit. Listings say which end each arm uses and whether the spherical ones come booted, because a bare one won't last in grit.
- How much camber is too much for a daily
- Enough that the inside edge wears out before the rest of the tread does. Factory spec or a hair past it is fine for a car that commutes. A camber figure that photographs well will eat the inside shoulder in a few months, and it's costing you braking in a straight line. Set it for the tires and the drive, not for the parking lot.
- Will arms fix my inner tire wear
- If camber caused it, yes. If toe caused it, a toe arm or a plain alignment does it. Inner wear that looks even all the way around is camber. Inner wear that feathers, smooth one direction and sharp the other, is toe. Grab the printout from the alignment shop and it'll tell you which one ran out of room.