Fog, DRL and Signal Lights

10 products

About Fog, DRL and Signal Lights

Fogs, DRLs and signals are what people fit after the headlights, and they're what makes a front end look finished. A fog lamp sits low and throws a wide flat beam under the fog line. A DRL runs all day at reduced power. A switchback shows white as a running light and turns amber when you signal. Most of this section is Morimoto.

Fog lights fit by bumper, not by model. A sport bumper and a base bumper on the same car take different housings, and a car that shipped without fogs may want the switch and the wiring too. Each listing says if it's a lens swap into an existing housing or a full kit with a harness. Yellow lenses cut a bit of glare in spray and mostly they just look right.

Signals bring the hyperflash question with them. An LED in a signal socket draws less current and plenty of cars flash fast to tell you a bulb's out. A resistor across the socket or an LED rated relay settles it. Switchback DRLs want a DRL circuit to exist on your car, and some trims only got one higher up the range. Side markers are the easy win.

By brand
MBRP10

Common questions

Do yellow fogs work better
A little, in rain and spray, and the rest of it is the look. Selective yellow cuts the blue end of the light, which is the part that bounces back at you off water. In clear weather a white fog puts more light on the road. Pick yellow for wet nights and the look, white if output is what you're after.
Why are my LED signals flashing fast
The flasher reckons a bulb has gone, because the LED pulls less current than the one it replaced. A load resistor across the socket or an LED rated relay fixes it. On a car with CANbus bulb monitoring you might need the resistor and a code clear on top. Each listing says what your car's going to want.
Can I add fogs if my car came without them
On most cars, yes, with a kit that brings the housings, the harness and a switch. Your bumper needs the opening, or a blank you can cut out, so look at yours first, since not every bumper's got one. Some cars already have the wiring behind a blank switch, and those are a housing and a switch away from working.
What are switchback signals
One LED unit that runs white as a daytime running light, turns amber while you're signaling and goes back to white after. The white side wants a DRL circuit or a separate feed and the amber side runs off the factory signal wire. On cars with no DRL circuit, the kit brings a harness to make one.